• Model Number: AP-G1405
• Place of Origin: Guangdong, China
• Minimum Order Quantity: 0 Pieces
• Supply Capacity: 0 Pieces/month
• MemberShip: Free Member
• Inquiry Now
• Bookmark & Share:

Description


1, Indroduction:
AP-G1405A/B is double component, room temperature curing silicone material, uses for LED packaging fill. After curing, it has high-light transmittance, good heat-stability, small stress, and low hygroscopicity etc..

2, technical parameter:
Item Technical parameter Before Curing(A component) Appearance Colourless transparent liquid viscosity mPa• s(25¡æ) 1050 Before Curing(B component) Appearance Colourless transparent liquid viscosity mPa• s(25¡æ) 1600 Mix ratio 1: 1 Mix- viscosity mPa• s(25¡æ) 1200 Operation time(25¡æ) 90min Typical Cure Condition 25¡æ× 24h After Curing Refractive(25¡æ) 1.41 Transmittance(£¥, 450 nm) ©ƒ95

3, Usage:
A: B=1: 1, can only be used after you remove the bubble in the condition of 10mmHg vacuum. Please operater in dry and clear.

4, Attentions:
Some of materials, chemical, curing agent, plasticizer can control the gel material’ s curing. There are are including:
1 organotin and other metallorganic compound
2 sulphur, polysulfide, polysulfone and other sulfur-containing
3 amine, polyester rubber and other ammoniac
4 phosphorig and other phosphorig-containing
5 Some flux residues If any doubt that whether some kind of material would restrain the curing, we suggest a compatibility experiment test for the suitability. If the uncured packaging materials exist the surface of the curing ones, then the curing incompatible, restrain curing.