• Model Number: AP-G1406
• Place of Origin: Guangdong, China
• Minimum Order Quantity: 0 Pieces
• Supply Capacity: 0 Pieces/month
• MemberShip: Free Member
• Inquiry Now
• Bookmark & Share:

Description


LED Silicone Package Material AP-G1406A/B

1, Introduction:
AP-G1406A/B is double component, adduct cured silicone materials,use for LED package and fill. After curing,it has high-light transmittance,good heat-stability,small stress and low hygroscopicity etc..

2, Technical parameter:
Item Technical parameter Before Curing (A component) Appearance Colourless transparent liquid Viscosity mPa•s(25¡æ) 1300 Before Curing (B component) Appearance Colourless transparent liquid Viscosity mPa•s(25¡æ) 800 Mix ratio 1: 1 Mix Viscosity mPa•s(25¡æ) 1000 Typical curing condition 25¡æ×12h(70¡æ×1h) Operate time(25¡æ) 90min After Curing Refractive(25¡æ) 1.41 transmittance(£¥, 450 nm) ©ƒ95 penetration(mm/10) 220¡«270

3, Usage:
A:B=1: 1, can only be used after you remove the bubble in the condition of 10mmHg vacuum. Please operater in dry and clear.

4, Attentions:
Some of materials,chemical,curing agent,plasticizer can control the gel material’s curing. There are are including:
1 organotin and other metallorganic compound
2 sulphur, polysulfide, polysulfone and other sulfur-containing
3 amine, polyester rubber and other ammoniac
4 phosphorig and other phosphorig-containing
5 Some flux residues If any doubt that whether some kind of material would restrain the curing, we suggest a compatibility experiment test for the suitability. If the uncured packaging materials exist the surface of the curing ones, then the curing incompatible, restrain curing.